3-bin mailbox components
CAUTION Disconnect the MFP power cord from the electrical outlet before disassembling
and reassembling the 3-bin mailbox. After the device is plugged back in for testing purposes,
do not touch the low-voltage power supply unit because this can cause electrical shock.
Rear cover
Insert a flat-blade screwdriver head and slightly lift the cover at the five points (callout 1) shown in the
following figure. Then remove the rear cover (callout 2).
1
2
Figure 5-219 Claw locations on rear cover
Front cover
Insert a flat-blade screwdriver head and slightly lift the cover at the five points (callout 1) shown in the
following figure. Then remove the front cover (callout 2).
1
2
Figure 5-220 Claw locations on front cover
Delivery tray
Lift the delivery tray (callout 1) and remove it.
350 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...