Hard drive
WARNING! The MFP contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the MFP chassis before
touching an ESD-sensitive component. Ground the MFP chassis before servicing the MFP.
1. Remove the formatter cover, and open the formatter-cage door.
2. Disconnect the power cable (5–wire, callout 1) from the hard drive.
3. Disconnect the data cable (2–wire, callout 2) from the hard drive.
Figure 5-33 Remove the hard drive (1 of 2)
242 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...