5. Let the test run for several hours or overnight.
6. If the test fails, an error message appears on the control-panel display. Replace the formatter.
7. To stop the test, turn the MFP off and then on. Make sure that you reconnect the network cable.
Ping test
Use the ping test to verify that the MFP is communicating over the network. Before performing the
ping test, obtain the IP address for a target destination, such as a PC, that is on the same network as
the MFP. Consult the network administrator for help with obtaining the IP address.
1. Scroll to and touch Administration.
2. Touch Management.
3. Touch Embedded Jetdirect or EIO <X> Jetdirect.
4. Touch Ping Test.
5. Set the appropriate options for each of the menu items that follow:
●
Dest Type
●
Dest IP
●
Packet Size
●
Timeout
●
Count
●
Print Results
●
Execute
After setting Execute to Yes, the ping test starts automatically. If you selected to print the results, a
page prints that lists the ping statistics. If the page prints, the test was successful.
ENWW Solve network connectivity problems 443
manuals4you.commanuals4you.com
To Next Page
Loading...