5. Remove two screws (1) that attach the stapler unit.
1
Figure 5-209 Remove the stapler unit (3 of 3)
Jogger unit
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the top cover.
4. Remove the bottom cover.
5. Remove the small plastic cover attached to the right side of the interface cable plate. Use your
thumb to pop the tabs out, then slide the cover off.
Figure 5-210 Remove the jogger unit (1 of 7)
344 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...