PS1305 Paddle home-position sensor
PS1306 Delivery-full sensor
Stapler/stacker driver PCB
The stapler/stacker driver controls the operational sequence of the stapler/stacker.
When the MFP is turned on and DC power is supplied to the stapler/stacker driver from the printer,
the stapler/stacker driver communicates with the formatter to start operational control. Then the
stapler/stacker enters stand-by mode and the stapler/stacker driver sends signals to drive loads,
such as motors and solenoids, in response to the command submitted from the printer.
The block diagram of the circuit is shown in the following figure.
Table 4-11 Cross-sectional view (part 2) (continued)
ENWW Stapler/stacker system 193
manuals4you.commanuals4you.com
To Next Page
Loading...