2. Peel back the ADF white, vinyl scan-background, and then remove the ADF output-bin extension.
Figure 5-183 Remove the ADF output-bin extension (2 of 2)
NOTE When the two screws are removed, the ADF output-bin extension is not captive.
Make sure that you support the ADF output-bin extension before you peel back the ADF
white, vinyl scan-background.
ADF white mylar-backing
1. Open the ADF, release two locking tabs (callout 1) and then open the mylar-holder assembly.
Figure 5-184 Remove the ADF white mylar-backing (1 of 3)
328 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...