7. You must replace the 18-tooth gear on this assembly, even if it is not worn, when you replace
the paper-pickup-drive assembly. Use a small, flat-blade screwdriver to unlatch the retaining
hook on the gear, and then remove the gear.
Figure 5-133 Remove the paper pickup drive assembly (6 of 6)
8. CAUTION: Do not let the pickup roller shaft slide into the MFP when you install the gear. The
groove on the shaft that the gear clips into can get stuck on the MFP chassis. Put pressure on
the cassette feed-roller shaft to keep the shaft from slipping into MFP. See the following figure.
Figure 5-134 Cassette feed-roller shaft (push here while replacing the gear)
Lifter-drive assembly
1. Remove the back cover.
298 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...