HP LaserJet M4345 MFP - Fuser-entrance guide; Fuser

Fuser-entrance guide
1. Remove the following assemblies.
●
Output bin.
●
Duplexer.
2. Flex the rear hinge-pin of the fuser-entrance guide until it clears the mounting hole in the MFP
chassis.
3. Rotate the rear of the guide away of the MFP and slide the guide to the left to release the front
hinge-pin. Remove the fuser-entrance guide.
Figure 5-20 Remove the fuser-entrance guide
Fuser
CAUTION The fuser is very hot. After turning the MFP power off, allow the fuser to cool for
at least 30 minutes before removing it.
1. Remove the following assemblies.
●
Output bin.
●
Duplex-printing unit.
●
Fuser-entrance guide.
ENWW User-replaceable parts 235
manuals4you.commanuals4you.com