Troubleshooting the embedded HP Jetdirect print server
If network-connection errors occur, you can disable the HP Jetdirect print server in order to
determine if the problem is with the print server or with the network. This procedure requires that you
temporarily install an optional EIO HP Jetdirect print server card while disabling the embedded
HP Jetdirect print server.
1. Turn the MFP off and then on.
2. When the memory count appears on the control-panel display, press and hold 6 until all three
LEDs flash once and then stay on. This might take up to 20 seconds.
3. Release 6, and then press and release 3 until EMBEDDED LAN DISABLE appears on the
control-panel display.
4. Press 6 one time, and wait for the MFP to complete its initialization sequence.
NOTE To enable the HP Jetdirect print server again, perform this same procedure.
EMBEDDED LAN ENABLE appears on the control panel.
ENWW Troubleshooting the embedded HP Jetdirect print server 463
manuals4you.commanuals4you.com
To Next Page
Loading...