5. The spring on the rear hinge is not captive and can easily be lost. Take note of how this spring
is installed before removing the tray assembly.
Figure 5-79 Correct tray 1 rear-hinge-spring placement
6. Move the paper-guide slightly toward the front of the MFP to disengage the paper-guide rear-
hinge. Remove the paper guide.
Figure 5-80 Remove the tray 1 assembly (5 of 5)
Front-cover support
1. Remove the tray 1 assembly.
2. Open the jam-access door.
ENWW Internal assemblies 269
manuals4you.commanuals4you.com
To Next Page
Loading...