Site preparation
Below are recommendations for the printer location and placement.
Operating environment
The printer must be kept in a proper location to maintain the performance level that has been set at
the factory.
The printer must have the required clearance around it.
109.2 cm
43 inches
546 mm
21.5 inches
122 mm
4.8 inches
863.6 mm
34 inches
419.1 mm
16.5 inches
787mm
30 inches
Figure 2-1 Printer dimensions
Place the MFP in a location that offers the following:
●
A well-ventilated, dust-free area
●
A constant temperature and humidity (Do not install near water sources, humidifiers, air
conditioners, refrigerators, or other major appliances.)
●
A hard, level surface (not more than a 2° angle)
Keep the MFP away from the following:
● Direct sunlight, dust, open flames, or water
●
Direct flow of exhaust from air ventilation systems
●
Magnets and devices that emit a magnetic field
22 Chapter 2 Installation ENWW
To Next Page
Loading...