2. Flex the front tab to release one side of the reversing-separation-guide assembly.
Figure 5-49 Remove the reversing-separation-guide assembly (1 of 2)
3. Lower the released side, and then pull the rear pivot-pin out of the metal bracket.
Figure 5-50 Remove the reversing-separation-guide assembly (2 of 2)
NOTE When it is installed, the reversing-separation-guide assembly normally fits loosely.
Reversing assembly
1. Remove the reversing-separation-guide assembly.
254 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...