3. Release the paper-feed-assembly alignment pins. Rotate the assembly toward the back of the
power supply, and remove it.
Figure 5-159 Remove the paper-feed assembly (2 of 2)
CAUTION Verify that the four rubber belts and plastic rollers remain in place. These
belts and rollers can easily come off and be lost. When you install the paper-feed
assembly, verify that the center foot (on the power-supply side) is correctly hooked under
the support leg that is on the engine power supply.
Tray 2 detection switch
1. Remove the PFC power supply.
2. Remove the cassette from tray 2.
312 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...