After performing an NVRAM initialization, reconfigure any computers that print to this MFP so that
the computers can recognize the MFP.
1. Turn the MFP off and then on.
2. Before the memory count appears on the control-panel display, press and hold 9 until all three
LEDs flash once and then stay on. This might take up to 20 seconds.
3. Press 3 one time, and then press Start.
4. Press 3 two times until NVRAM INIT appears on the control-panel display.
5. Press 6 one time, and wait while the MFP completes its initialization sequence.
Hard-disk initialization
A hard-disk initialization erases and reformats the hard disk. Perform a hard-disk initialization only if
an error message on the control-panel indicates a disk error. Always try initializing the hard disk
before replacing it.
NOTE Before performing a hard-disk initialization, print a menu map and a Configuration
page. Use the information on these pages to reset any customer-specific settings.
CAUTION A hard-disk initialization deletes the following information: all stored copy jobs, the
local address book (e-mail addresses), the speed-dial list (fax numbers), and the Java™
applet files.
1. Turn the MFP off and then on.
2. Before the memory count appears on the control-panel display, press the right-hand side of the
Start button until all three LEDs are lit. Release the Start button.
3. Press 5 one time. INITIALIZE DISK appears on the control-panel display.
4. Press 6 one time. A series of asterisks appears on the control-panel display. Wait for the MFP
to complete its initialization sequence.
458 Chapter 6 Problem solving ENWW
To Next Page
Loading...