5. Disconnect one connector (callout 4; J92) from the DC controller.
Figure 5-131 Remove the paper-pickup-drive assembly (4 of 6)
NOTE The tray 2 pickup-solenoid (SL101) is part of the paper-pickup-drive assembly.
6. Remove four screws (callout 5), and then remove the paper-pickup-drive assembly.
5
Figure 5-132 Remove the paper-pickup-drive assembly (5 of 6)
ENWW Internal assemblies 297
manuals4you.commanuals4you.com
To Next Page
Loading...