2. Unsnap the output-bin-full sensor from the retaining clips. Unsnap the clips at the rear of the
MFP first, and work toward the front.
Figure 5-165 Remove the output-bin-full sensor
NOTE When installing the sensor, make sure that the flag (front end) is in front of the
output-bin-detection lever. If the flag is not in front of the lever, this sensor will not
function correctly.
3. Carefully remove the spring from the from the formatter-end of the output-bin-full sensor.
CAUTION This spring can easily become dislodged from the chassis. Do not lose this
spring when you remove this assembly.
ENWW Internal assemblies 317
manuals4you.commanuals4you.com
To Next Page
Loading...