8. Slide the scanner slightly to the right, and then lift it up and off of the MFP.
Figure 5-178 Remove the scanner assembly (8 of 8)
CAUTION Make sure that you do not release the scanner latch while the scanner
assembly is removed. The gas shocks that support the scanner assembly can damage
the sheet-metal scanner-assembly platform if the platform is raised when the scanner
assembly is not installed.
9. Reinstallation tip: When you reinstall the scanner assembly, align the mark on the scanner
assembly with the mark on the control panel to correctly position the scanner assembly. With
the scanner assembly correctly positioned on the sheet metal platform, slide the assembly
toward the left side of the MFP until it locks into place.
Figure 5-179 Correctly positioning the scanner assembly
ENWW ADF and scanner components 325
manuals4you.commanuals4you.com
To Next Page
Loading...