9. Remove four screws.
Figure 5-215 Remove the jogger unit (6 of 7)
10. Remove the jogger assembly carefully from under the link arm (1), under the cable guide (2),
and around sensor PS1306 (3).
1
2
3
Figure 5-216 Remove the jogger unit (7 of 7)
NOTE When installing the new jogger-unit assembly, be sure to align the ridges on the sides
of the PS1306 cable with the grooves on the inside of the PS1306 connector.
ENWW Stapler/stacker components 347
manuals4you.commanuals4you.com
To Next Page
Loading...