Menu item Sub-menu item Sub-menu item Values and Description
Manual Settings Use this item to manually set IPv6 addresses on the
print server.
Enable: Select this item and choose On to enable
manual configuration, or Off to disable manual
configuration.
Address: Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
Proxy Server Specifies the proxy server to be used by embedded
applications in the device. A proxy server is typically
used by network clients for Internet access. It caches
Web pages, and provides a degree of Internet
security, for those clients.
To specify a proxy server, enter its IPv4 address or
fully-qualified domain name. The name can be up to
255 octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy
server address.
Proxy Port Type the port number used by the proxy server for
client support. The port number identifies the port
reserved for proxy activity on your network, and can
be a value from 0 to 65535.
IPX/SPX Enable
Off: Disable the IPX/SPX protocol.
On (default): Enable the IPX/SPX protocol.
Frame Type Selects the frame-type setting for your network.
Auto: Automatically sets and limits the frame type to
the first one detected.
EN_8023, EN_II, EN_8022, and EN_SNAP: Frame-
type selections for Ethernet networks.
AppleTalk Enable
Off (default): Disable the AppleTalk protocol.
On: Enable the AppleTalk protocol.
DLC/LLC Enable
Off (default): Disable the DLC/LLC protocol.
On: Enable the DLC/LLC protocol.
Table 3-10 Jetdirect menus (continued)
ENWW Control-panel menus 63
manuals4you.commanuals4you.com
To Next Page
Loading...