Menu item Sub-menu item Sub-menu item Values and Description
SNMP Test This test checks operation of SNMP communications
by accessing predefined SNMP objects on the device.
Select Yes to choose this test, or No to not choose it.
Select All Tests Use this item to select all available embedded tests.
Select Yesto choose all tests. Select No to select
individual tests.
Data Path Test This test helps to identify data path and corruption
problems on an HP postscript level 3 emulation
device. It sends a predefined PS file to the device,
However, the test is paperless; the file will not print.
Select Yes to choose this test, or No to not choose it.
Execution Time [H] Use this item to specify the length of time (in hours)
that an embedded test will be run. You can select a
value from 1 to 60 hours. If you select zero (0), the
test runs indefinitely until an error occurs or device is
turned off.
Data gathered from the HTTP, SNMP, and Data
Path tests is printed after the tests have completed.
Execute No*: Do not initiate the selected tests.
Yes: Initiate the selected tests.
Ping Test This test is used to check network communications.
This test sends link-level packets to a remote
network host, then waits for an appropriate
response. To run a ping test, set the following items:
Dest Type Specify whether the target device is an IPv4 or IPv6
node.
Dest IP IPV4: Type the IPv4 address.
IPV6: Type the IPv6 address.
Packet Size Specify the size of each packet, in bytes, to be sent
to the remote host. The minimum is 64 (default) and
the maximum is 2048.
Timeout Specify the length of time, in seconds, to wait for a
response from the remote host. The default is 1 and
the maximum is 100.
Count Specify the number of ping test packets to send for
this test. Select a value from 1 to 100. To configure
the test to run continuously, select 0.
Print Results If the ping test was not set for continuous operation,
you can choose to print the test results. Select Yes
to print results. If you select No (default), results are
not printed.
Execute Specify whether to initiate the ping test. Select Yes
to initiate the test, or No to not run the test.
Table 3-10 Jetdirect menus (continued)
ENWW Control-panel menus 65
manuals4you.commanuals4you.com
To Next Page
Loading...