221
8. Enable the router to
exchange IPv6 unicast
routing information used for
RPF check with peers in the
specified peer group.
peer
group-name
enable
By default, the router cannot
exchange IPv6 unicast routing
information used for RPF check
with the peers in the group.
To configure an EBGP peer group by using Method 3 (IPv4 unicast address family):
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
b. ip vpn-instance
N/A
3. Create an EBGP peer group.
group
group-name
external
By default, no EBGP peer groups
exist.
4. Add a peer into the EBGP
peer group.
peer
ipv4-address [ mask-length ]
group
group-name
as-number
as-number
By default, no peers exist in the
peer group.
5. (Optional.) Configure a
description for the peer
group.
peer
group-name
description
text
By default, no description is
configured for the peer group.
6. Create the BGP IPv4 unicast
address family or BGP-VPN
IPv4 unicast address family
and enter its view.
address-family ipv4
[
unicast
]
By default, no BGP IPv4 unicast
address family or BGP-VPN IPv4
unicast address family exists.
7. Enable the router to
exchange IPv4 unicast
routing information with
peers in the specified peer
group.
peer
group-name
enable
By default, the router cannot
exchange IPv4 unicast routing
information with the peers.
To configure an EBGP peer group by using Method 3 (IPv6 unicast address family):
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
N/A
To Next Page
Loading...
Need help?
General