513
EBGP direct connections after link failure, 262
EBGP peer protection (low memory
exemption), 276
EBGP session establishment (multiple hop),
261
enable, 207
fake AS number advertisement, 253
first AS number of EBGP route update ignore,
256
FRR configuration, 290
GR configuration, 284
GTSM configuration, 270
holdtime configuration, 259
IGP route redistribution, 226
IPv4 basic configuration, 303
IPv4 BFD configuration, 329
IPv4 COMMUNITY configuration, 316
IPv4 confederation configuration, 321
IPv4 dynamic peer configuration, 340
IPv4 FRR configuration, 333
IPv4 GR configuration, 328
IPv4 IGP route redistribution, 307
IPv4 link state (LS) configuration, 342
IPv4 load balancing configuration, 313
IPv4 multicast configuration, 337
IPv4 path selection configuration, 325
IPv4 route reflector configuration, 319
IPv4 route summarization, 310
IPv6 basic configuration, 344
IPv6 BFD configuration, 353
IPv6 FRR configuration, 361
IPv6 multicast configuration, 365
IPv6 packet IPsec configuration, 356
IPv6 route reflector configuration, 347
keepalive interval configuration, 259
large scale network management, 198
large-scale network configuration, 279
link state (LS) configuration, 295
load balancing, 197
load balancing configuration, 267
local AS number appearance, 251
local network injection, 224
LS route reflection configuration, 296
manual soft reset configuration, 274
MED attribute configuration, 245
message types, 192
MP-B G P, 201
MP-BGP address family, 201
MP-BGP extended attributes, 201
MPLS local label update delay, 277
multi-instance, 202
network optimization, 258
NEXT_HOP attribute, 249
nonstop routing (NSR) configuration, 286
optimal route advertisement, 229
optimal route selection disable for labeled routes,
279
ORIGINATOR_ID attribute ignore, 283
OSPF BGP advertisement of link state
information, 103
outgoing packet DSCP value, 278
path attributes, 192
path selection control, 241
peer, 192
peer configuration, 208
peer configuration (IPv4 unicast address), 208
peer configuration (IPv6 unicast address), 209
peer group configuration, 213
peer keychain authentication, 266
peer MD5 authentication, 265
per-prefix label allocation enable, 279
private AS number removal, 255
protocols and standards, 204
received route preferred value, 241
route advertisement rules, 196
route dampening configuration, 240
route distribution control, 227
route filtering policy, 233
route flapping logging, 287
route generation, 224
route preference configuration, 243
route reception control, 227
route recursion, 197
route reflection, 281
route reflector configuration, 281
route refresh enable, 271
route selection, 196, 197
route summarization, 227
route update delay, 239
route update interval, 260
route update save, 272
routes received limit (peer/peer group), 232
routing policy AS_PATH list, 492
routing policy COMMUNITY list, 492
session establishment disable, 269
session state change logging, 286
SNMP notification enable, 286
soft reset configuration, 271
SoO attribute configuration, 257
speaker, 192
startup policy for BGP route updates, 239
suboptimal route flush to RIB, 278
To Next Page
Loading...
Need help?
General