Huawei SmartAX MA5608T User Manual

It will take several minutes to save configuration file, please wait...
huawei(config)#
Configuration file had been saved successfully
Note: The configuration file will take effect after being activated
huawei(config)#
The data is being saved, please wait a moment...
huawei(config)#
1 [2010-07-12 14:35:05+08:00]:The percentage of saved data on 9 slot's main
control board is: 21%
huawei(config)#
1 [2010-07-12 14:35:08+08:00]:The percentage of saved data on 9 slot's main
control board is: 27%
huawei(config)#
1 [2010-07-12 14:35:11+08:00]:The percentage of saved data on 9 slot's main
control board is: 66%
huawei(config)#
1 [2010-07-12 14:35:14+08:00]:The percentage of saved data on 9 slot's main
control board is: 72%
huawei(config)#
1 [2010-07-12 14:35:17+08:00]:The percentage of saved data on 9 slot's main
control board is: 78%
huawei(config)#
1 [2010-07-12 14:35:20+08:00]:The percentage of saved data on 9 slot's main
control board is: 96%
huawei(config)#
1 [2010-07-12 14:35:23+08:00]:The percentage of saved data on 9 slot's main
control board is: 98%
huawei(config)#
huawei(config)#
1 [2010-07-12 14:35:25+08:00]:The data of 9 slot's main control board is
saved
completely
Manually backing up data
1. For configuring and enabling the FTP tool on the backup sever, see Configuring the FTP
Transfer Mode.
2. Select one of the following modes to back up the database file or the configuration file to
the server.
l Assume that the IP address of the backup server is 10.10.10.1 and the database file name
is data0.dat. To back up the database file to the backup server through FTP, do as
follows:
huawei(config)#backup data ftp 10.10.10.1 data0.dat
Command:
backup data tftp 10.10.10.1
data0.dat
Please save database file before backup, or the database file that is
backed
up may be not the lastest one. Are you sure to continue? (y/n)[n]: y
Load(backup,duplicate,...) begins, please wait and notice the rate of
progress
Any operation such as reboot or switchover will cause failure and
unpredictable result
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
130

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE