access points (APs) to provide wireless fidelity (Wi-Fi) access for users. This section describes
how to configure the MA5633 to provision the WLAN hotspot radio backhaul service.
Service Requirements
A network supplier needs to provide the Internet access service through Wi-Fi for a business
area covered by APs.
Usage Scenario
As shown in Figure 16-13, an MA5633 is deployed on an optical node and CMs are deployed
at shops. The CMs connect to RF ports on the MA5633 through cables.
l A CM connects to wireless APs to provide the WLAN hotspot radio backhaul service. The
wireless APs provide Wi-Fi access for users.
l Wi-Fi users access the Internet through Dynamic Host Configuration Protocol (DHCP)
dialup.
Figure 16-13 WLAN hotspot radio backhaul service networking
Configuration
The method of configuring the WLAN hotspot radio backhaul service is the same as that of
configuring the L2VPN enterprise service and therefore is not described in this section. For
details, see 16.4.2.2 Configuration Process.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1794
To Next Page
Loading...
Need help?
General
