b. Add an ONU line profile.
Add GPON ONU line profile 10 and bind T-CONT 5 to the DBA profile named Data.
In this way, the T-CONT can provide flexible DBA solutions based on different
configurations in the DBA profile.
huawei(config)#ont-lineprofile gpon profile-id 10
huawei(config-gpon-lineprofile-10)#tcont 5 dba-profile-name Data
Add GEM port 0 for transmitting management traffic streams, GEM port 1 for
transmitting data traffic streams. Bind GEM port 0 and GEM port 1 to T-CONT 5.
Configure the QoS mode to priority-queue (default) and the queue priority to 3.
huawei(config-gpon-lineprofile-10)#gem add 0 eth tcont 5 priority-queue 3
huawei(config-gpon-lineprofile-10)#gem add 1 eth tcont 5 priority-queue 3
Configure the mapping mode from the GEM port to ONU-side service to VLAN
(default), map the service port of management VLAN 8 to GEM port 0, map the service
port of SVLAN 100 to GEM port 1.
huawei(config-gpon-lineprofile-10)#mapping-mode vlan
huawei(config-gpon-lineprofile-10)#gem mapping 0 0 vlan 8
huawei(config-gpon-lineprofile-10)#gem mapping 1 1 vlan 100
After the configuration is complete, run the commit command to make the configured
parameters take effect.
huawei(config-gpon-lineprofile-10)#commit
huawei(config-gpon-lineprofile-10)#quit
c. (Optional) Add an alarm profile.
l The ID of the default GPON alarm profile is 1. The thresholds of all the alarm
parameters in the default alarm profile are 0, which indicates that no alarm is
generated.
l In this example, the default alarm profile is used, and therefore the configuration
of the alarm profile is not required.
l Run the gpon alarm-profile add command to add an alarm profile, which is used
for monitoring the performance of an activated ONU line.
4. Add an ONU on the OLT.
The ONU is connected to the GPON port of the OLT through an optical fiber. You can
perform the service configuration only after adding an ONU successfully on the OLT.
a. Add an ONU.
Connect the ONU to GPON port 0/3/1. The ONU ID is 1, the SN is
48575443E6D8B541, the management mode is SNMP, and the bound line profile ID
is 10.
There are two ways to add an ONU. Select either of the two ways according to actual
conditions.
l Add an ONU offline: If the password or SN of an ONU is obtained, you can run
the ont add command to add the ONU offline.
l Automatically find an ONU: If the password or SN of an ONU is unknown, run
the port ont-auto-find command in the GPON mode to enable the ONU auto-find
function of the GPON port. Then, run the ont confirm command to confirm the
ONU.
To add an ONU offline, do as follows:
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#ont add 1 1 sn-auth 48575443E6D8B541 snmp ont-
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1810
To Next Page
Loading...
Need help?
General
