l The default alarm profile is GPON alarm profile 1, in which each alarm threshold is 0,
indicating that no alarm is reported.
l This topic uses the default alarm profile. Therefore, you do not need to configure the
profile.
l If necessary, run the gpon alarm-profile add command to add a GPON alarm profile
to measure and monitor the performance of activated ONT lines.
4. Add an ONU to the OLT.
The ONU connects to a GPON port on the OLT using an optical fiber. You can configure
services only after adding the ONU to the OLT.
a. Add the ONU.
Connect the ONU to GPON port 0/3/1 using an optical splitter. The ONU ID is 1, the
SN is 48575443E6D8B541, the management mode is SNMP, and the ID of the bound
line profile is 10.
You can use either of the following methods to add an ONU:
l Add an ONU in offline mode. If you have obtained the password or SN of an ONU,
run the ont add command to add it in offline mode.
l Use the ONU automatic discovery function. If the password or SN of an ONU is
unknown, run the port ont-auto-find command in GPON mode to enable the ONU
automatic discovery function. Then run the ont confirm command to confirm the
automatically discovered ONU.
To add an ONU in offline mode, run the following commands:
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#ont add 1 1 sn-auth 48575443E6D8B541 snmp ont-
lineprofile-id
10 desc MA5621_0/3/1/1_lineprofile10
To add an ONU using the ONU automatic discovery function, run the following
commands:
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#port 1 ont-auto-find enable
huawei(config-if-gpon-0/3)#display ont autofind 1
//This command displays the information about all ONUs connected to the
GPON port using an optical splitter.
------------------------------------------------------------
Number : 1
F/S/P : 0/3/1
Ont SN : 48575443E6D8B541
Password :
VenderID : HWTC
Ont Version : MA5621
Ont SoftwareVersion : V800R310C00
Ont EquipmentID : SmartAX MA5621
Ont autofind time : 2011-09-10 11:20:16
------------------------------------------------------------
huawei(config-if-gpon-0/3)#ont confirm 1 ontid 1 sn-auth 48575443E6D8B541
snmp ont-lineprofile-id
10 desc MA5621_0/3/1/1_lineprofile10
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1853
To Next Page
Loading...
Need help?
General
