Name: Huawei SmartAX MA5608T
Brand: Huawei
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Figure 1-74 shows the flowchart for commissioning the interconnection with the MG interface

(H.248).

Figure 1-74 Flowchart for commissioning the interconnection with the MG interface(H.248)

Prerequisites

l The data configuration on the MGC side (corresponding to the data configuration on the

MG side) must be correct.

l The current system must use the H.248 protocol.

NOTE

Run the display protocol support command to query the current voice protocol. If the voice protocol

is not H.248, run the protocol support h248 command to change it to H.248.

Procedure

Step 1 Configure the upstream VLAN interface for the media stream and the signaling stream.

The VLAN ID is 50, the VLAN type is smart VLAN, the upstream port is 0/19/0, and the IP

address of the VLAN interface is 10.50.1.10/24.

huawei(config)#vlan 50 smart

huawei(config)#port vlan 50 0/19 0

huawei(config)#interface vlanif 50

huawei(config-if-vlanif50)#ip address 10.50.1.10 24

huawei(config-if-vlanif50)#quit

SmartAX MA5600T/MA5603T/MA5608T Multi-service

Access Module

Commissioning and Configuration Guide

1 Commissioning

Issue 01 (2014-04-30) Huawei Proprietary and Confidential

166

Other manuals for Huawei SmartAX MA5608T

Questions and Answers:

Need help?

Do you have a question about the Huawei SmartAX MA5608T and is the answer not in the manual?

General