The management IP address of the CPE is 192.168.10.10/24.
huawei(config)#cpe-management ip-address 192.168.10.10
Step 2 Configure the management VLAN of the CPE.
The VLAN ID is 30, the VLAN type is smart VLAN, and the IP address of the VLAN L3
interface is 192.168.10.11/24.
huawei(config)#vlan 30 smart
huawei(config)#cpe-management vlan 30
huawei(config)#interface vlanif 30
huawei(config-if-vlanif30)#ip address 192.168.10.11 24
huawei(config-if-vlanif30)#quit
Step 3 Configure the management VPI and VCI of the CPE.
The management VPI ID is 0, and the management VCI ID is 35.
huawei(config)#cpe-management vpi 0 vci 35
Step 4 Configure the management flow type of the CPE.
The management flow type is vlan-ethertype ipoe.
huawei(config)#cpe-management flow-type vlan-ethertype ipoe
Step 5 Configure IPoA.
Configure MAC address pool 0 with the start address 0000-0000-0001.
huawei(config)#mac-pool 0 0000-0000-0001
Enable the IPoA protocol conversion function.
huawei(config)#ipoa enable
Set the IPoA default gateway.
huawei(config)#ipoa default gateway 10.1.1.1
Step 6 Log in to the CPE.
huawei(config)#cpe-management telnet 0/2/0
----End
Result
You can log in to the CPE from the MA5600T/MA5603T/MA5608T using the maintenance
terminal to maintain and manage the CPE.
Configuration File
cpe-management ip-address 192.168.10.10
vlan 30 smart
cpe-management vlan 30
interface vlanif 30
ip address 192.168.10.11 24
quit
cpe-management vpi 0 vci 35
cpe-management flow-type vlan-ethertype ipoe
mac-pool 0 0000-0000-0001
ipoa enable
ipoa default gateway 10.1.1.1
cpe-management telnet 0/2/0
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
184
To Next Page
Loading...
Need help?
General
