Huawei SmartAX MA5608T User Manual

5. The packets are sent over the PSN network to the peer PWE3 gateway (such as the PTN).
6. The PWE3 gateway restores the E1 signals from the packets and then sends them to the
DDN network or SDH network.
Networking
Figure 4-7 shows an example network of TDM PWE3 (MPLS-based).
Figure 4-7 Example network of TDM PWE3 (MPLS-based)
MPLS
Network
SHDSL Modem
Access
Node
PWE3
Gateway
SHDSL
E1
PRI PBX
SDH
E1
E1
TDM PWE3
Data Plan
Table 4-8 lists the data plan for configuring TDM PWE3 (MPLS-based).
Table 4-8 Data plan for configuring TDM PWE3 (MPLS-based)
Parameter Data
H802EDTB board Board slot: 0/4
E1 port: 0/4/5
SPUB board Board slot: 0/5
MPLS VLAN for MPLS forwarding: 4001
IP address of VLAN interface 4001: 10.50.50.50/24
MPLS LSR ID: 3.3.3.3
Global MPLS LDP: enabled
MPLS LDP for VLANIF 4001: enabled
MPLS Layer 2 VPN: enabled
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 4 Configuration Example of the Private Line Service
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
426

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE