Huawei SmartAX MA5608T User Manual

> 4: G.HS (G.
992.1~5)
> 5: ADSL (G.
992.1~2,ETSI,T1.413)
> 6: ADSL2 & ADSL2+ (G.
992.3~5)
> Please select (0~6)
[1]:
> Trellis mode 1-disable 2-enable (1~2)
[2]:
> Bit swap downstream 1-disable 2-enable (1~2)
[2]:
> Bit swap upstream 1-disable 2-enable (1~2)
[2]:
> Please select the form of transmit rate adaptation
downstream:
> 1-fixed, 2-adaptAtStartup, 3-adaptAtRuntime (1~3)
[2]:
> Please select the form of transmit rate adaptation
upstream:
> 1-fixed, 2-adaptAtStartup, 3-adaptAtRuntime (1~3)
[2]:
> Will you set SNR margin parameters? (y/n)
[n]:
> Will you set DPBO parameters? (y/n)
[n]:
> Will you set power management parameters? (y/n)
[n]:
> Will you set tone blackout configuration parameter? (y/n)
[n]:
> Will you set INM downstream parameter? (y/n)
[n]:
> Will you set RFI notch configuration parameter? (y/n)
[n]:
> Will you set mode-specific parameters? (y/n)
[n]:
> Will you set network timing reference? (y/n) [n]:
Add profile 10 successfully
2. Configure the ADSL2+ channel profile.
You can configure the ADSL2+ channel profile based on your requirements.
huawei(config)#adsl channel-profile add 10
Start adding
profile
Press 'Q' to quit the current configuration and new configuration will
be
neglected
> Do you want to name the profile (y/n)
[n]:n
> Data path mode 1-ATM, 2-PTM, 3-Both (1~3) [3]:
1
> Will you set the minimum impulse noise protection? (y/n)
[n]:y
> Minimum impulse noise protection
downstream:
> 1-noProtection 2-halfSymbol 3-singleSymbol 4-
twoSymbols
> 5-threeSymbols 6-fourSymbols 7-fiveSymbols 8-
sixSymbols
> 9-sevenSymbols 10-eightSymbols 11-nineSymbols 12-
tenSymbols
> 13-elevenSymbols 14-twelveSymbols 15-thirteenSymbols 16-
fourteenSymbols
> 17-fifteenSymbols 18-
sixteenSymbols
> Please select (1~18) [2]:
4
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
5 Configuration Example of MSTP Subtending Network
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
448

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE