Huawei SmartAX MA5608T - Page 50

2. Set the line delay and the character delay of the ASCII code.
Click ASCII Setup. In the dialog box that is displayed, set line delay to 200 and Character
delay to 200, and then click OK, as shown in the following figure. By default, Line
delay is 0, and Character delay is 0.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25