Configure PW2 and PW3 as a PW protection group named pg_pw. Set the working mode to
master-slave and enable the dual receiving function for PWs. In the protection group enabled
with dual receiving, two PWs are always allowed to receive traffic. In this way, when the remote
device performs traffic switching, the traffic will not be dropped.
huawei(config)#vsi enterprise_vpn
huawei(config-vsi-enterprise_vpn)#protect-group pg_pw
huawei(config-vsi-enterprise_vpn-group-pg_pw)#pw-protect primary-pw pwindex 2
secondary-pw pwindex 3
huawei(config-vsi-enterprise_vpn-group-pg_pw)#protect-mode master
huawei(config-vsi-enterprise_vpn-group-pg_pw)#stream-dual-receiving
Step 9 Bind AC and VSI.
Bind QinQ VLAN 100 to the VSI named enterprise_vpn, so that the enterprise private line
service packets can be forwarded in the VSI.
huawei(config-vsi-enterprise_vpn)#vsi-ac-binding vlan 100
----End
Result
As shown in Figure 6-3, the private networks distributed in different branches can establish
point-to-multipoint communication with each other and various services can be provisioned
between these private networks. When a PE which branch C is connected to is faulty, services
can be automatically switched to another PE and therefore services are not affected.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 6 Configuration Example of VPLS
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
505
To Next Page
Loading...
Need help?
General
