l Set the SysContact.
huawei(config)#snmp-agent sys-info contact HW-075512345678
l Set the SysLocation.
huawei(config)#snmp-agent sys-info location Shenzhen China
l Set the SNMP version.
The SNMP version must be the same as the SNMP version of the NMS. In this
example, the SNMP version is set as SNMP V2C.
huawei(config)#snmp-agent sys-info version v2c
5. Enable the trap sending.
huawei(config)#snmp-agent trap enable standard
6. Set trap destination address.
huawei(config)#snmp-agent target-host trap-hostname huawei address 2.2.2.2
trap-paramsname abc
huawei(config)#snmp-agent target-host trap-hostname huawei123 address 2.2.2.3
trap-paramsname 123
7. Set the trap source address.
huawei(config)#snmp-agent trap source vlanif 10
Step 3 Configure the time server.
huawei(config)#ntp-service unicast-server 4.4.4.4 source-interface vlanif 10
huawei(config)#ntp-service unicast-server 4.4.4.5 source-interface vlanif 10
Step 4 Configure the log host.
huawei(config)#loghost add 3.3.3.3 syslog-1
huawei(config)#loghost activate ip 3.3.3.3
huawei(config)#loghost add 3.3.4.3 syslog-2
huawei(config)#loghost activate ip 3.3.4.3
Step 5 Configure the EMU.
This topic uses the fan monitoring as an example to show how to configure the EMU.
By default, the default slave node number of the fan EMU is 0. In this example, assume that the
slave node number is 1. In this case, you need to set the DIP switch of the node address on the
fan monitoring unit as 1.
huawei(config)#emu add 0 h801ESC 0 0
huawei(config)#emu add 1 fan 0 1
Step 6 Configure the VDSL2 service.
The MA5600T supports the VDSL2 Internet service of multiple encapsulation modes, such as
IPoA, PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode as an example to describe
how to configure the VDSL2 service. For other encapsulation modes, see "3.1 Example:
Configuring the xDSL Internet Access Service."
1. Configure the VDSL2 line profile.
You can configure the VDSL2 line profile based on your requirements.
huawei(config)#vdsl line-profile add 10
Start adding profile
Press 'Q' to quit the current configuration and new configuration will
be
neglected
> Do you want to name the profile (y/n) [n]:
> Transmission mode:
> 0: Custom
> 1: All (G992.1~5,T1.413,G993.2)
> 2: Full rate(G992.1/3/5,T1.413,G993.2)
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
7 Example: Subtending Networking
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
539
To Next Page
Loading...
Need help?
General
