– If the upstream port does not learn a MAC address, check the network connections
between the upstream port and upper-layer devices and check the configurations
of upper-layer devices.
– If the downstream port does not learn a MAC address, check whether the ONT is
activated and whether physical links are normal.
– If both the upstream and downstream ports can learn the MAC address, record the
MAC address of the ONT and log in to the service router (SR) to check whether
an IP address is allocated to the MAC address.
3. Check the registration status of the voice service.
– You can run the display ont port state command on the OLT to query the call
connection status on the POTS port. If Call State is RegisterFail or
Connecting for a long time, check whether the voice configuration on the MGC/
SIP server is consistent with that on the ONT.
– If the ONT uses the H.248 protocol, you can run the display ont mg status
command on the OLT to query the registration status of the MG interface that
connects to the ONT. If MG Status is UnRegistered or Registering for a long
time, check whether the voice configuration on the MGC/SIP server is consistent
with that on the ONT.
– You can query the registration status of the voice service on the ONT web page.
If the query result shows that the registration fails or the voice service is in the
registering state for a long time, check whether the voice configuration on the
MGC/SIP server is consistent with that on the ONT.
l Verify the multicast service using multicast emulation.
1. Run the igmp static-join command to simulate a multicast user to order a multicast
program.
huawei(config)#btv
huawei(config-btv)#igmp static-join service-port 1 ip 224.1.1.10 vlan 1000
NOTE
If the multicast program is obtained dynamically, igmp static-join can be executed successfully
only when the range for obtaining the dynamic program is set.
2. Run the display igmp user command to query the status of the multicast user.
huawei(config-btv)#display igmp user service-port 1
User : 0/1/0/1
State : online
Authentication : no-auth
Quick leave : MAC-based
IGMP flow ID : 1
Video flow ID : 1
Log switch : enable
Bind profiles : -
IGMP version : IGMP v3
Current version : IGMP v3
Current IGMP IPv6 version : IGMP IPv6 v2
Available programs : 8
Global leave : disable
User max bandwidth : no-limit
Used bandwidth(kbps) : 0
Used bandwidth
to max bandwidth(%) : -
Total video bandwidth : -
Mcast video bandwidth : -
Active program list
-------------------------------------------------------------------------
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
628
To Next Page
Loading...
Need help?
General
