Item Step Description
OLT
ONU
U2000
Configure the
VoIP service.
10.6.1.6
Configuring
the H.248-
based Voice
Service
(Through the
CLI)
NOTE
l The H.248 and Session Initiation Protocol
(SIP) protocols are mutually exclusive for the
VoIP service. Either of them is configured at
a time.
l The voice service can be configured through
command line interface (CLI) on an OLT,
web page, or U2000. Select a configuration
mode based on site requirements.
l OLT CLI: This mode can be used for site
deployment or the U2000 has not been
deployed.
l Web page: This mode can be used to
configure voice parameters after the
service channel has been configured
through the OLT CLI. It can be used for
site deployment.
l U2000: This mode can be used to
configure voice parameters after the
service channel has been configured
through the OLT CLI. It can be used for
service provisioning in batches.
10.6.1.7
Configuring
the H.248-
based Voice
Service (on a
Web Page)
10.6.1.8
Configuring
the SIP-based
Voice Service
(Through the
CLI)
10.6.1.9
Configuring
the SIP-based
Voice Service
(on a Web
Page)
OLT
HGW
Configure the
IPTV service.
10.6.1.10
Configuring
the BTV
Service
IPTV services include the BTV and VoD
services that are different in configuration
procedures and need to be configured
separately.
10.6.1.11
Configuring
the VoD
Service
OLT 10.6.1.12 Verifying Services The OLT provides remote verification
methods including ONU PPPoE/DHCP
dialup emulation and call emulation for
configuration and commissioning engineers
to verify services remotely after service
configuration, avoiding a second on-site
operation.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
10 FTTD Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
743
To Next Page
Loading...
Need help?
General
