Remote
Service
Verificati
on
Method
Function Remarks
PPPoE
dialup
emulation
An ONT emulates PPPoE user
terminal software to perform dialup
and interact with the BRAS to verify
the connectivity between the ONT and
BRAS.
PPPoE dialup emulation requires a
service flow which does not belong to
a QinQ VLAN.
A user name, password, and
authentication mode must be
configured on the BRAS for the
PPPoE dialup emulation.
An ONU supports a maximum of one
PPPoE dialup emulation.
Call
emulation
An ONT emulates a VoIP user to make
a call to check whether the VoIP
service data is correctly configured.
You can also use the call emulation
function to locate a fault when the
VoIP service is faulty.
l An ONU can emulate the caller or
callee in a call to a phone.
Therefore, a functioning phone is
required in the central office where
the acceptance personnel is.
l An ONU can emulate the caller
and callee simultaneously in an
emulation test. No phone is
required in the test.
l An ONU supports a maximum of
one call emulation.
Multicast
emulation
This function enables you to emulate
a multicast user going online and lead
the program stream to an ONU. By
querying the real-time traffic of the
multicast program, you can check
whether the multicast function is
performing well.
The multicast service that is
configured in the dynamic
controllable multicast mode does not
support remote verification.
Data plan
Item Data Remarks
PPPoE
dialup
emulation
parameter
Service flow ID: 101
Emulation timeout time: 10s
The entered user name, password, and
authentication mode must be
consistent with those configured on
the BRAS.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
970
To Next Page
Loading...
Need help?
General
