Huawei SmartAX MA5608T User Manual

Item Data Remarks
Call
emulation
parameter
Caller port: 0/3/0
Callee port: 0/3/23
Callee telephone number: 83110024
The ONU emulates the caller and
callee at the same time using the
default emulation parameters. You
can view the parameters by running
the display pots emulational
configuration command.
Multicast
emulation
parameter
Multicast service flow ID: 401
Multicast VLAN: 1000
IP address of the multicast program:
224.1.1.10
-
Procedure
l Verify the Internet access service using PPPoE dialup emulation.
1. Start an emulation test by running the simulate dhcp start command.
huawei(config)#pppoe simulate start
Command:
pppoe simulate start
Service-port(index<0-999>):101
User Name(length<1,65>):user0
User Password(length<0,16>):*******
Authentication Mode:
1. Chap 2. Pap [default 1]:1
Overtime Time(5-60s)[default 5]:10
2. Query the emulation test information by running the display pppoe simulate info
command.
huawei(config)#display pppoe simulate info
PPPoE simulate information is:
-----------------------------------------------------------------
Service-port: 101
User name: user0
Current phase: - //*Emulation phase
Result: Success //*Emulation result
Start time: 2011-11-16 15:41:29+08:00
End time: 2011-11-16 15:41:34+08:00
Session ID: 591
User IP: 192.168.50.2
Gateway IP: 192.168.50.254
-----------------------------------------------------------------
3. Terminate the emulation test by running the simulate dhcp start command.
huawei(config)#pppoe simulate stop
l Verify the voice service using call emulation.
1. Start an emulation test by running the ont emulational call command.
huawei(config)#test
huawei(config-test)#pots emulational-call caller-port 0/3/0 callee-port
0/3/23 callee-telno 83110024
2. The ONU outputs the call emulation result after the test is complete.
The ONU outputs the call emulation result and failure of the cause if the emulation
test fails.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
971

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE