Huawei SmartAX MA5608T User Manual

huawei(config-test)#
Caller port : 0/3/0
Callee port : 0/3/23
Test result : Test Succeed
l Verify the multicast service using multicast emulation.
1. Run the igmp static-join command to order a multicast program by emulating a
multicast user.
huawei(config)#btv
huawei(config-btv)#igmp static-join service-port 401 ip 224.1.1.10 vlan
1000
2. Run the display igmp use command to query the status of the multicast user.
huawei(config-btv)#display igmp user service-port 401
User : 0/3/1 //*Use an ETH port as an example.
State : online
Authentication : no-auth
Quick leave : MAC-based
IGMP flow ID : 0
Video flow ID : 0
Log switch : enable
Bind profiles : -
IGMP version : IGMP v3
Available programs : 91
Global Leave : disable
User MaxBandWidth : no-limit
Used bandwidth(kbps) : 5000
The percentage of used
bandwidth to port rate(%) : -
Total video bandwidth : -
Mcast video bandwidth : -
Active program list
-------------------------------------------------------------------------
--
Program name VLAN IP/MAC State Start-time
-------------------------------------------------------------------------
--
program1 1000 224.1.1.10 watching 2011-07-13
14:41:18
-------------------------------------------------------------------------
--
Total: 1
3. Run the display multicast flow-statistic command to query the real-time traffic of
the multicast program.
huawei(config-btv)#display multicast flow-statistic ip 224.1.1.10 vlan
1000
Command is being executed, please wait...
Multicast flow statistic result: 360(kbps)
l Verify the VoD service.
1. Run the display mac-address service-port command on the ONU to query learned
MAC addresses of VoD users. The learned MAC addresses of VoD users indicate that
services are functioning properly between the ONU and VoD users.
If the VPI/VCI is 0/35 and the ADSL2+ port is 0/2/0, run the following command to
query the learned MAC addresses of VoD users:
huawei(config)#display mac-address service-port 301
Command:
display mac-address service-port 301
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
972

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE