Husqvarna TE 310 - Engine Reassembly

H.2 Part. N. 8000 H1344 (10-2009)
ENGINE REASSEMBLY
General directions ................................................... H.3
Instructions for assembly and lubrication ................. H.4÷H.13
Reassembly of crankshaft ........................................ H.14
Reassembly of counter balancing shaft driving gear
(SMR 450-510) ......................................................... H.16
Reassembly of transmission (TE-TXC-SMR) ........... H.17
Reassembly of transmission (TC) ............................ H.18
Reassembly of crankcase ........................................ H.20
Reassembly of gearshift mechanism, electric starting
system and oil pump................................................. H.24
Reassembly of gear lever shaft ................................ H.25
Reassembly of kick start components (TE-TC-TXC) . H.26
Reassembly of clutch (TE-TXC-TC; SMR 450-510) H.27
Reassembly of timing system drive gear and chain . H.29
Reassembly of ywheel ............................................ H.30
Reassembly of transmission cover ........................... H.31
Reassembly of piston and cylinder ........................... H.32
Reassembly of cylinder head ................................... H.33
Reassembly of cam-chain tensioner (TE-TC-TXC-SMR)
H.36
Reassembly of valve lifter......................................... H.37
Reassembly of cylinder head cover, spark plug,
lubrication hose ........................................................ H.39
Reassembly of gear shift position sensor ................. H.39
Reassembly of ywhel cover .................................... H.40
Reassembly of the gearshift pedal and
kick start pedal (TC-TE-TXC) ................................... H.41
Reassembly of the engine oil lters and drain plug .. H.41
Engine and motorcycle reassembly.......................... H.42
Cylinder head gasket selection chart........................ H.44