EasyManua.ls Logo

Husqvarna TE 310 - Filling with Oil

Husqvarna TE 310
420 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I.23
Part. N. 8000 H1344 (10-2009)
FRONT SUSPENSION
FILLING WITH OIL
The R5051AC is available as spare part: if you tighten it on the rod’s edge,
you can make the rod extraction from the inner part of the slide easier.



OIL AMOUNT FOR EACH STEM:
TE: 725cm
3
SMR: 740cm
3

few times to remove any traces of air.


the wheel axle clamp.


A lower or higher volume of air, or a type of oil other than the recommended
type can change the behaviour of the fork in every phase.











paragraph 5).
h
31
13
84
02
52
12
h =100 mm (3.94 in) SMR
h =120 mm (4.72 in) TE
84
32
R
84

Table of Contents

Related product manuals