Husqvarna TE 310 - Air Filter Check (TC-TXC)

D.18 Part. N. 8000 H1344 (10-2009)
SETTINGS AND ADJUSTMENTS
Air lter check (TC-TXC)
Turn rear pin (1) counterclockwise, remove it and release the saddle from the
front fastening screw.
TXC: Take out the battery (A) and place it sideways on the vehicle.
To gain access to the air lter, lift a little the electronic power unit (2). Remove
screw (3) and the lter (4). Separate lter (5) from frame (6).
AIR FILTER AND CLEANING
Wash lter with a specic detergent (”CASTROL FOAM AIR FILTER CLEANER”
or similar) then dry it fully (wash lter with gasoline only in case of necessity).
Plunge lter in special oil for lters ("CASTROL FOAM AIR FILTER OIL" or
similar), then wring it to drain superuous oil.
: Do not use gasoline or a low ash-point solvent to clean the element. A
re or explosion could result.
: Clean the element in a well ventilated area, and do not allow sparks or
ames anywhere near the working area.
1
6
5
4
3
A
TXC