S.6
Part. N. 8000 H1344 (10-2009)
FUEL INJECTION SYSTEM
Relay check
Remove the saddle and the the fuel tank as shown on pages E.15-E.23. Remove
the relays (1) located on the frame, R.H. side (no. 1) and L.H. side (no. 2).
A: set the meter on "Impedance" position and check that the exciter coil functions
properly; the value will have to be: 80 Ohm (+/- 10%) at 20°C.
B: set then the meter on "Continuity" position and check that the circuit is
open.
C: using a 12V stabilized feeler for the coil and check that the circuit is closed.
1
1
1
To Next Page
Loading...
