D.20 Part. N. 8000 H1344 (10-2009)
SETTINGS AND ADJUSTMENTS
AIR FILTER AND CLEANING
Wash lter with a specic detergent (”CASTROL FOAM AIR FILTER CLEANER”
or similar) then dry it fully (wash lter with gasoline only in case of necessity).
Plunge lter in special oil for lters ("CASTROL FOAM AIR FILTER OIL" or
similar), then wring it to drain superuous oil.
: Do not use gasoline or a low ash-point solvent to clean the element. A
re or explosion could result.
: Clean the element in a well ventilated area, and do not allow sparks or
ames anywhere near the working area.
ASSEMBLY
To ensure tight t, slightly (C) grease lter edge on side facing lter housing.
While re-inserting the lter into its housing, make surs that piece (A) is turned
upwards and edge (B) is on the left lower side of the lter case. Reassemble the
parts previously removed (battery: connect the positive cable rst).
: If the element assembly is not installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of the piston rings and cylinder.
To Next Page
Loading...
