IAI PCON-CB series User Manual

4. Operation
4.4 Operation of Field Network Type
4-128 ME0342-4B
4.4 Operation of Field Network Type
In the field networks, the following operation modes are available to choose from for operation.
(Except for the motion network)
Operation should be made with the data necessary for operation (such as target position,
velocity, acceleration, pressing current, etc.) written in the determined addresses from such as
PLC connected to the host.
For details regarding operation of each field network, refer to the instruction manuals listed below.
PCON-CB/CFB/CBP Type
Field Network
Name
Description Details
Supported models
CB/CFB CBP
CC-Link
Control of the actuator is available
with I/O communication using the
control signals same as those for
PIO or the numerical data
communication.
Refer to the other
ME0254
(Note 1)
○ ○
CC-Link IE Field
Refer to the other
ME0389
(Note 1)
○ ○
CompoNet
Refer to the other
ME0220
(Note 1)
○ ○
DeviceNet
Refer to the other
ME0256
(Note 1)
○ ○
EtherCAT
Refer to the other
ME0273
(Note 1)
○ ○
EtherNet/IP
Refer to the other
ME0278
(Note 1)
○ ○
MECHATROLINK-I/II
Refer to the other
ME0221
(Note 1)
○ ○
PROFIBUS-DP
Refer to the other
ME0258
(Note 1)
○ ○
PROFINET IO
Refer to the other
ME0333
(Note 1)
○ ○
MECHATROLINK-III
Synchronized control of several
actuators in highly constant
periodicity is available.
Refer to the other
ME0317
(Note 1)
○ ×
RS485
Actuator is controlled with using a
general protocol “Modbus”
communication.
Refer to the other
ME0162
(Note 1)
○ ○
Note 1 PCON-CB/CFB/CBP are the slave units (slave stations).
Refer to the instruction manual of the master unit of each supplier and PLC to be
mounted for the details of each network.
For the instruction of the field network for PCON-CB/CFB/CBP, the instruction manual is
provided separately. Use the manual together with this manual.
Note 2 PCON-CBP is not applicable for MECHATROLINK-III.

IAI PCON-CB series Specifications

General

Brand	IAI
Model	PCON-CB series
Category	Controller
Language	English