ME0342-4B
2.7 Installation and Storage Environment ············································ 2-26
2.7.1 Installation Environment ··········································································· 2-26
2.7.2 Storage and Preservation Environment ······················································· 2-26
2.8 Noise Elimination and Mounting Method ········································ 2-27
2.8.1 Noise Elimination···················································································· 2-27
2.8.2 Installation and Mounting ········································································· 2-28
Chapter 3 Wiring
3.1 Positioner Mode (PIO Control) ····················································· 3-1
3.1.1 Wiring Diagram (Connection of Devices) ····················································· 3-1
3.1.2 PIO Pattern Selection and PIO Signal ························································· 3-2
3.1.3 Wiring ·································································································· 3-7
3.2 Pulse Train Control Mode ···························································· 3-26
3.2.1 Wiring Diagram (Connection of Devices) ····················································· 3-26
3.2.2 I/O Signals in Pulse Train Control Mode and Each Functions ·························· 3-27
3.2.3 Wiring ·································································································· 3-29
3.3 Wiring Method ·········································································· 3-42
3.3.1 Wiring Layout of Power Supply Connector ··················································· 3-42
3.3.2 Connection to Actuator ············································································ 3-43
3.3.3 Connection of PIO ·················································································· 3-44
3.3.4 Connection of Pulse Train Signal ······························································· 3-45
3.3.5 SIO Connector Connection ······································································· 3-47
3.3.6 Field Network Connector of PIO ································································ 3-48
Chapter 4 Operation
4.1 Basic Operation ········································································ 4-1
4.1.1 How to Turn on Power ············································································· 4-1
4.1.2 Basic Operation Methods ········································································· 4-2
4.1.3 Parameter Settings ················································································· 4-8
4.2 Operation in Positioner Mode ······················································· 4-9
4.2.1 Operation Modes of Rotary Actuator in Multiple Rotation Mode and
Command Limitations ·············································································· 4-11
4.2.2 Set of Position Table (This section is not required in selection of
pulse train control mode.) ········································································· 4-12
4.2.3 Control of Input Signal ············································································· 4-21
4.2.4 Operation Ready and Auxiliary Signals (Common to Patterns 0 to 7) ················ 4-22
4.2.5 Operation with the Position No. Input (PIO Patterns 0 to 3 and 6) ····················· 4-36
4.2.6 Direct Position Specification (Operation of PIO Pattern 4 and 7) ······················ 4-63
4.2.7 Direct Position Specification (PIO Pattern 5) ················································ 4-85
4.2.8 Preparation for Operation in Force Sensor Pressing (Loadcell Calibration) ········· 4-96
To Next Page
Loading...
