IDEC MICRO3 User Manual

18: TROUBLESHOOTING
USER’S MANUAL 18-17
Troubleshooting Diagram 11
Turn the input for the PULS or
PWM instruction on.
Correct the pulse width coeffi-
cient setting to 0 through 249.
Is the pulse
width coefficient set to
0 through 249?
Is error indicator
ERR1 on?
Is the input for the PULS
or PWM instruction on?
YES
NO
NO
YES
YES
Call IDEC for assistance.
NO
Make sure of correct wiring for
output Q0.
Output pulses are not generated at output Q0
when using the PULS or PWM instruction.
Is the output indicator
for output Q0 on?
END
See Troubleshooting Diagram 3,
“Error indicator ERR1 is on.”
NO
YES

IDEC MICRO3 Specifications

General

Brand	IDEC
Model	MICRO3
Category	Controller
Language	English