141
9.5.2 Power cable (CFQ-6776)······································································································243
9.5.3 Selecting a long cable ···········································································································243
9.6 After-installation Adjustments ·······································································································244
9.6.1 Installation-time check···········································································································244
9.6.2 Functional checks··················································································································244
9.6.3 Adjustment items ···················································································································244
9.6.4 Rectifier unit ···························································································································245
9.7 Adjustment Procedures·················································································································246
9.7.1 General adjustments ·············································································································246
1. Adjustments to be made when a part is replaced ···································································246
2. CRT monitor off center adjustment ··························································································246
3. Adjusting the brilliance level of the CRT monitor screen. ·······················································246
4. Adjusting the focus of the CRT monitor screen·······································································246
9.7.2 Adjusting the scanner unit·····································································································247
1. Adjusting the AVR output voltage from the modulator····························································247
2. Adjusting the tuning indicator level of the receiver ··································································247
9.7.3 Adjusting the display unit ······································································································247
1. Adjusting the brilliance level······································································································247
2. Adjusting the focus of the CRT monitor screen·······································································247
3. Adjusting the tilt angle of the display unit ·················································································248
4. Adjusting the CRT display ········································································································248
5. Adjusting the AVR output voltage ····························································································248
9.8 Initial Settings·································································································································249
9.8.1 Adjustment of the receiver ····································································································250
1. Tune preset································································································································250
2. Adjusting the central frequency ································································································251
3. Adjusting the level of the tune level indicator···········································································251
9.8.2 Adjusting the noise level ·······································································································252
9.8.3 Adjusting the bearing·············································································································252
9.8.4 0 NM adjustment (Initial setting of distance)········································································253
9.8.5 Setting the antenna height····································································································254
9.8.6 Presetting the sensitivity········································································································255
9.8.7 Presetting the sea clutter ······································································································255
9.8.8 Suppression of main bang····································································································256
9.8.9 Display of simulator image····································································································257
9.8.10 Setting the TD reception number ·························································································258
9.8.11 GPS/DGPS····························································································································259
1. Initial setting of GPS····················································································································259
2. Initial setting of DGPS·················································································································259
3. Status of reception of GPS and DGPS······················································································260
To Next Page
Loading...
