249
9.8 Initial Settings
This section will explain the method of initial setting of the radar unit. Initial setting
needs to be undertaken prior to initial use.
Initial setting includes:
(a) INITIAL SETTING 1
• Tuning preset (TUNE PRESET)
• Bearing adjustment (BEARING)
• 0 NM adjustment (DISPLAY TIMING)
• Main bang suppression level (MBS LEVEL)
• Main bang suppression range (MBS RANGE)
• Sensitivity preset (GAIN PRESET)
• Comparator preset (COMPARATOR PRESET)
• Sea surface clutter preset (STC PRESET)
• Antenna height preset (ANTENNA HEIGHT)
• GPS preset (GPS PRESET)
(b) INITIAL SETTING 2
• Setting the TD reception number (SET TD NUMBER)
• Simulator image display (SIMULATOR)
Be sure to undertake initial setting prior to initial use.
Unless initial setting has been undertaken, it is not possible to display the target or
measure the distance or bearing of a target correctly.
INITIAL SETTING 1, the initial setting menu that is used here, is displayed by
pushing the ＥＮＴＥＲ key and ＭＥＮＵ key simultaneously.
Attention
To Next Page
Loading...
Need help?
General
