257
(d) Push the soft key 1 and select
ＥＸＰ
ＥＸＰＥＸＰ
ＥＸＰ
ＯＦＦ
ＯＦＦＯＦＦ
ＯＦＦ
.
(e) Push the the soft key
ＰＲＯＣＥＳＳ
ＰＲＯＣＥＳＳＰＲＯＣＥＳＳ
ＰＲＯＣＥＳＳ
.
(f) Push the soft key 1 and select
ＡＵＴＯ
ＡＵＴＯＡＵＴＯ
ＡＵＴＯ
ＯＦＦ
ＯＦＦＯＦＦ
ＯＦＦ
.
(g) Turn the [GAIN] control to the maximum (turn to maximum clockwise).
(h) Turn the [SEA] control to the mid position.
(i) Turn the [RAIN] control to the minimum (turn to maximum counterclockwise).
(j) Select "MBS LEVEL" in the menu "INITIAL SETTING 1".
(k)
Adjust the suppression level pushing the "▲ (up)" or "▼ (down)" on the
ＲＡＮＧＥ
ＲＡＮＧＥＲＡＮＧＥ
ＲＡＮＧＥ
key.
(l) Push the
ＥＮＴＥＲ
ＥＮＴＥＲＥＮＴＥＲ
ＥＮＴＥＲ
key.
The suppression level of the main bang has been determined.
(
m
) Select "MBS RANGE" in the menu "INITIAL SETTING 1".
(n)
Adjust the suppression range pushing the "▲ (up)" or "▼ (down)" on the
ＲＡＮＧＥ
ＲＡＮＧＥＲＡＮＧＥ
ＲＡＮＧＥ
key.
(o) Push the
ＥＮＴＥＲ
ＥＮＴＥＲＥＮＴＥＲ
ＥＮＴＥＲ
key.
Adjustment of the suppression range of the main bang has been completed.
9.8.9 Display of simulator image
By activating this function, it is possible to display a demonstration screen on the PPI
screen.
To make the setting of this function effective, the power must be once switched off.
(a) Push the
ＳＴＢＹ／ＯＦＦ
ＳＴＢＹ／ＯＦＦＳＴＢＹ／ＯＦＦ
ＳＴＢＹ／ＯＦＦ
key.
The display will enter the standby mode.
To Next Page
Loading...
Need help?
General
