Kinco FD5P AC series servo driver
Chapter 4 Controller setup with LED panel
4.3 Easy Use Function
Easy Use is designed to quickly set control ring parameters for users, eliminating the tedious steps
of servo debugging, and the adjusted performance can meet most applications; In addition, an
independent area is created to facilitate users to set commonly used important parameters.
4.3.1 Setup process with Easy Use Function
Step 1: Confirm EASY flow parameters one by one. After the EASY process is executed, run the machine,
and if the performance is ideal, there is no need to perform the tunE process. Otherwise, follow the
tunE process
Step 2:The tunE process is the inertia measurement process. After the inertia is measured through the
tn03, the drive changes the rigidity class (tn01) according to the tuning result.
Step 3: Please run the machine, if the performance is not ideal, and then modify the rigidity level step
by step through tn01, please note that while adjusting, observe the machine performance.
Figure 4-2 Gain self-tuning process
Note
Inertia measurement may cause the machine to vibrate. Please turn off the
power or the drive immediately
Turning on the inertia measurement will make the motor shaft reciprocate
within a small distance, please leave a certain mechanical space.。
After executing the EASY process, it is strongly recommended to perform the tunE
process to measure the inertia and adjust the rigidity level.
To Next Page
Loading...
Need help?
General
